Single-Phase Machine; Start Up And Stop; Checking The Correct Electrical Connection - Berkel BM +32T Mode D'emploi Et D'entretien

4.4.1 - 380 Volt-50Hz three-phase machine and 220 Volt-50 Hz three-phase
machine
In these set ups the machine is outfitted with a
feeding cable with a section of 4 x 1.5 mm.
This is a connection to a three-
pole + grounding three-phase
plug.
Connect the cable to the three-phase feeding network,
interplacing a 16-Amp magnetothermic differential switch.
4.4.2 - 220 Volt-50 Hz single-phase machine
In this set up the machine is outfitted with a
feeding cable with a section
of 3 x 1.5 mm.
This is connected to a three-
pole
Connect the cable to the 220 Volt-50 Hz single-phase feeding
network, interplacing a 16-Amp magnetothermic differential
switch.
In set ups with voltages different from those mentioned, consult the manufacturer.
If the feeding cable must be prolonged, use a cable with the same section as the
one installed by the manufacturer.

5 - Start up and stop

5.1 - Checking the correct electrical connection

Connect the plug to the electrical outlet;
Press the start pushbutton ("1" Fig. 3.1.1 ), checking the rotation direction of the
tools (in the 380 three-phase version).
The rotation direction must be counter-clockwise.
If the rotation direction is incorrect, disconnect the machine from the electrical
supply and contact the dealer in your area.
Note:
For the machines connected to a single-phase line and made for such feeding, the
correct rotation direction is directly defined by the manufacturer.
5.2 - Checking the presence and efficiency of the protection and
safeties
1 - Product outlet.
Check that the plates on the product outlet have holes with a diameter smaller than
8 mm. If they do not, the outlet must be installed with a proper protection.
2 - Hand guard
The hopper must have a hand guard.
3 - Stainless steel hopper.
The stainless steel hopper is firmly welded onto the casing.
4 - Electrical component protection carters.
Make sure they are fitted, intact and correctly fastened to the internal parts of the
single-phase plug.
14
N: usually it is of blue colour or by N° 4 indicated