Deletion Of Radio Codes; Control Leds; Operation Of The Display - Genius LYNX 06/230V Mode D'emploi

5. Within 5 seconds, press, on the new radio control, the push-button you wish to associate with the selected
channel.
6. After the new radio control has been stored in the memory, the control unit keeps the learning mode active on
the selected channel for about 5 seconds.
7. During these 5 seconds, other radio controls can be memory stored on the control unit, as ever associated with
the activated channel.
8. When 5 seconds have elapsed from memory-storage of the last radio control, the control unit automatically exits
the learning stage.
9. To check if the radio control was correctly memory stored, wait for 5 seconds after sending the code.

7.3. DELETION OF RADIO CODES

To delete all the radio controls stored in the memory, go through the following procedure:
1. Press and hold down one of the two push-buttons P3 or P4.
The relevant LED begins to flash.
2.
3. After five seconds, the LED starts to flash at high speed.
4. After another five seconds both LEDS, DL7 and DL8 light up on steady beam.
5. Release the push-button.
This operation is irreversible, and all radio controls associated with both the OPEN/CLOSE and the CLOSE command
will be deleted.
There are 8 control LEDs on the control unit, displaying the state of the inputs. The meanings of the LEDs are shown on
the table below
LEDs
DL1 - Opening travel limit device FCA Opening travel limit device not engaged
DL2 - Closure travel limit device FCC
DL3 - CLOSE input
DL4 - OPEN/CLOSE input
DL5 - FSW safety devices input
DL6 - STOP input
DL7 - OPEN/CLOSE radio input
DL8 - CLOSE radio input
The bold print indicates the condition of the LEDs with the automated system closed at rest.
If STOP devices are not connected, make a connection between terminals 18 & 20. LED DL6 must always be
lighted.
If safety devices are not used, make a connection between terminals 17 & 20. LED DL5 must always be
lighted.
The control unit has a back-lit display enabling you to view and program the operating parameters of the automated
system. Furthermore, it always shows the state of the automated system during normal operation. The following table
shows all the indications on the display during normal operation:
Displayed value
– –
Automated system closed at rest
O P Automated system opening or open
t c
Automated system on pause (only with the selected automatic re-closure)
C L Automated system closing
Motor heating: it is shown only during the heating phase (to activate the function, see next
r r
paragraph)
Assistance request: it is shown only if the relevant parameter was enabled and if the number
A S
of set cycles has been reached.

8. CONTROL LEDS

ON
Closure travel limit device not engaged
Input active
Input active
Safety devices not engaged
Input not active
Radio channel active
Radio channel active

9. OPERATION OF THE DISPLAY

State of automated system / description
22
OFF
Opening travel limit device engaged
Closure travel limit device engaged
Input not active
Input not active
Safety devices engaged
Input active
Radio channel not active
Radio channel not active