Complete The Finished Wall - Continued; Complete The Concrete Installation; Clean-Up After Installation - Kohler K-1360 Mode D'emploi

Apply silicone
sealant to the
joint between the
finished wall and
the whirlpool rim.

11. Complete the Finished Wall - Continued

Tiled Ledge Installation
If you have not already done so, carefully remove the protective tape from the whirlpool rim.
Cover the framing with water-resistant wall material.
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall
material. Seal the joints between the whirlpool rim and the finished wall material with silicone
sealant.
NOTE: The exposed area of the whirlpool rim must not be less than 37-5/8" (95.6 cm) x 72" (182.9 cm) in
order for the pillows to fit properly.
Install the faucet trim according to the instructions packed with the trim.
Install the grip rails according to the installation instructions packed with the grip rails.

12. Complete the Concrete Installation

If you have not already done so, carefully remove the protective tape from the whirlpool rim.
Apply mortar and tile to the wall, deck and surround material as needed.
Apply a bead of sealant where the tile meets the whirlpool surface.
Install the faucet trim according to the instructions packed with the trim.

13. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the
whirlpool surface. If necessary, use warm water and a liquid detergent to clean the surface of the
whirlpool, user keypad and remote control.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods
of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire
brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild
abrasive action to any residual plaster.
Kohler Co.
Install the finished
ledge material.
First install water-resistant
wall material.
Framing
Install the finished
wall material.
Whirlpool Flange
13
Apply silicone sealant to the
joint between the finished
wall and the whirlpool rim.
Finished
Ledge
1022211-2-C