Table des Matières
Publicité
7. Complete the Installation
Clips/Clips/Clips
CAUTION: Risk of property damage. Make sure that a watertight seal exists
around the drain and overflow.
NOTE: If you have not already done so, remove the apron panel following the
instructions below.
Removing the Apron Panel
Insert a flat-blade screwdriver or other prying tool into one of the two screwdriver
slots.
Use the screwdriver to pry the bottom clip out and release the clip.
When all bottom clips are released, pull the bottom of the panel away from the
apron to release the remaining clips.
When the bottom of the panel is clear, lower the panel until the top of the panel is
clear.
Complete the Installation
Connect the drain to the trap according to the drain manufacturer's instructions.
Install the faucet trim, bath spout, shower door, and any accessories according to
each manufacturer's instructions.
Remove the protective covering from the bath.
Open the water supply lines, then run the water to flush out any debris.
Close the valves.
Check all connections for leaks.
Sterling
Tabs
Languettes
Lengüetas
Apron Frame
Cadre du bandeau
Estructura del faldón
Apron Panel
Panneau du bandeau
Panel del faldón
19
1072812-2-A
Publicité
Table des Matières
