Complete The Installation; Important Safety Instructions - Kohler Archer Serie Guide D'installation Et D'entretien

Clockwise to
Decrease the Flow
Position the jet
nozzles to direct
the water flow as
desired.

5. Complete the Installation

Test Run the Whirlpool
Fill the whirlpool to a level at least 2" (51 mm) above the top of the highest jet.
Operate the whirlpool for 5 minutes and check all whirlpool piping connections for leaks. Check for
leakage along the front, sides, and back of the whirlpool.
For additional information on whirlpool operation, see the "Operating Instructions" section.
Finish the Installation
Install water-resistant wallboard and all finished wall, deck, and floor materials.
Apply silicone sealant to seal all areas where the whirlpool and finished wall or deck meet.
Install the faucet trim.
Clean-up After Installation
When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the
whirlpool surface. Use warm water and a liquid detergent to clean the surface of the whirlpool.
Remove stubborn stains or paint with turpentine or paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with any whirlpool surface for long periods of time.
Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or
other metal tools. Use a powder-type detergent on a damp cloth to provide mild abrasive action to
any residual plaster.

Important Safety Instructions

READ AND FOLLOW ALL INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
WARNING: When using electrical products, basic precautions should always be followed,
including the following:
DANGER: Risk of accidental injury or drowning. To reduce the risk of injury, do not permit
children to use this unit unless they are closely supervised at all times.
Kohler Co.
Counterclockwise
to Increase the Flow
SAVE THESE INSTRUCTIONS
Fill with water at least 2" (51 mm)
above the highest jet.
9 1193346-2-A