OPERATING INSTRUCTIONS
Working in Automatic mode (self-leveling):
In automatic mode the laser level will level itself in the
range of ±3° and will project crossed horizontal and
vertical laser beams.
1. Remove the laser from the case and place it on a solid
flat Vibration free surface or on a tripod.
2. Push the locking switch #1 forward to the ON position.
The laser level will generate the crossed horizontal and
vertical lines and the green LED will light up.
3. If the initial slope of the laser is beyond ±3° the laser
lines will flash. In this case reposition the laser on a
more leveled surface.
4. Before moving the laser level switch the locking switch
#1 backward to the OFF position, this will lock the
pendulum and protect your laser.
10