Kapro Prolaser Cross 862 Manuel D'utilisation page 11

NS
Working in Manual mode:
In manual mode the self-leveling mechanism of 862G is
disabled and the laser lines can be set at any slope required.
1. Long press on the Manual mode push button (#3) will
activate the Manual mode. The laser will project blinking
cross lines and the red LED will light up.
2. Tilt the laser to the desirable slope.
3. To turn the manual mode OFF , press again Manual
mode push button.
4. While in Manual mode turning the locking switch #1
from OFF to ON position will turn off the Manual mode
and the red LED near the push button. The automatic
self – leveling will be activated if the laser level is within
the self – leveling range.
11