Operating Instructions - Kapro Prolaser Multi Beam Manuel D'utilisation

Working in Automatic mode (self-leveling):
In automatic mode the laser level will level itself in ± 3°
range and will project horizontal 360° beam, vertical beam
and 2 plumb dots.
1. Remove the laser level from the case and place it on a
solid, flat, vibration free surface or on a tripod.
2. Push the locking switch #1 to the ON position. The laser
level will project all the beams: a 360° horizontal beam,
vertical beam and 2 plumb dots. The beam indicator (b)
will turn on.
3. Press the beam selector button (a) to choose the required
laser beams by cycle:
All beams => Horizontal beam only => Vertical beam
only => Horizontal + Vertical beams => Plumb dots only
=> All beams.
4. If the initial inclination of the laser level is beyond ± 3°
and the automatic mode is activated, the laser beams will
flash. In this case reposition the laser level on a more
level surface.
5. Before moving the laser level, turn the locking switch
#1 to the OFF position, this will lock the pendulum and
protect your laser level.
10

OPERATING INSTRUCTIONS