Information; Problem Solving - Sentiotec A1 Instructions De Montage Et Mode D'emploi

2

Information

Is the bathing temperature not attained or is the temperature different from the thermometer in the cabin? Please
ensure that the temperature sensor is positioned in the area of the heating system. The thermometer is always in
a different place (e.g. on the back wall of the cabin over the lying area). But the sensor can only record the tem-
perature in its direct environment. Distances of as little as 25 cm between the sensor and thermometer can lead
to temperature differences of up to 15°C. Added to this is the fact that many bimetal thermometers can react very
sluggishly. Consequently, the actual temperature is sometimes only displayed after approx. one hour. Where pos-
sible, the thermometer should not be installed with the complete housing area on the cabin wall, but at a distance.
The reaction time is thus reduced. It can therefore be absolutely normal for your thermometer to display a lower
value than you have set on the control device.+
CAUTION:
The sensor cables must be installed separately from other network and control cables.
3

Problem solving

Dear customer,
You are in possession of a high quality, technical device. We can assure you that this product has been produced
and individually tested by us with state-of-the-art manufacturing methods. If, contrary to expectations, this device
gives a cause for complaint, we request that you provide an error description which is as accurate as possible in
the interests of rapid handling of repairs. The relevant temperature sensor(s) for each control unit must be returned
to us in principle.
WORLD OF WELLNESS
Instructions for use for the user P. 6/10