Battery Installation & Safety - Kapro Prolaser 3D All-Lines 883G Manuel D'utilisation

BATTERY INSTALLATION & SAFETY
1. Press down the ledge of the battery cover.
2. Insert the battery contact terminals forward according to the
shape of the battery compartment.
3. Close the battery cover.
4. Charge the Li- Ion battery if Beam/Battery indicator (b) starts
to flash instead of steady lighting.
5. You can charge the Li- Ion battery inside the laser during
the work or outside the Laser using the charger with the
charging adaptor.
6. Connecting the charger with the charging adaptor to the
power will show steady green diode with small blinking red dot.
7. During the charging the battery indicator on the charging
adaptor will light in red, and will turn green when the battery
is fully charged.
8. You can use the laser without the Battery, by connecting the
charger to the power and to the charging port in the laser.
Li- Ion battery
7