Kapro Prolaser 3D All-Lines 883G Manuel D'utilisation page 11

Working in Manual mode:
In Manual mode the 883N self-leveling mechanism is disabled and
the laser beams can be set at any slope required.
1. Verify that the locking switch #1 is on the OFF position.
2. Press and hold the Manual mode button (a) for 3 sec to activate
the manual mode. The laser level will project a 360° horizontal
beam, that will flash every 3 sec. to let you know that the beam is
not leveled. The beam indicator (b) will turn on.
3. To mark a slope, tilt the laser to the desired angle.
4. To choose another beam, press the beam selector button (a).
5. Briefly press the beam selector button (a). It will project a 360°
vertical side flashing beam in addition to the horizontal beam.
6. Additional click on the beam selector button (a) will add a 360°
forward vertical flashing beam.
7. Additional click on the beam selector button (a) will switch OFF
all the beams and the beam indicator (b) will turn off.
8. While in Manual mode, turning the locking switch #1 from OFF
to ON will turn off the Manual mode. The automatic self – leveling
mode will be activated (if the laser level is within the self –
leveling range).
9. Additional click on the lines button switch (a). This will switch
all the beams OFF.
10.While in Manual mode, turning the locking switch #1 from OFF
to ON will turn off the Manual mode. The automatic self – leveling
mode will be activated (if the laser level is within the self –
leveling range).
11