Télécharger Imprimer la page

Power Fist 8727679 Manuel De L'utilisateur page 17

Publicité

Les langues disponibles

Les langues disponibles

V4.1
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Fails to split logs
The log pusher
moves jerkily,
making odd
noise or vibrating
a lot.
Oil leaks around
cylinder ram or
from other
points.
Visit www.princessauto.com for more information
9 Ton Electric Log Splitter
Possible Cause(s)
1. Log is improperly
positioned
2. The log's size or
hardness exceeds the
equipment's capacity.
3. Blunt cutting wedge.
4. Oil leaks
5. Max. Pressure Limiting
Screw was adjusted by
non-technician.
1. Lack of hydraulic oil
2. Excessive air in the
hydraulic system.
1. Air sealed in hydraulic
system while operating.
2. Bleed Screw is not
tightened before moving
the log splitter
3. Oil Drain Bolt with
Dipstick is not tight.
4. Hydraulic Control Valve
Assembly and/or seal(s)
worn.
Suggested Solution(s)
1. Refer to Operation for correct
log loading.
2. Reduce the log sizes before
placing it on the log splitter.
3. Refer to Sharpening the
Wedge.
4. Locate leak(s) and contact a
qualified technician.
5. Contact qualified technician
to reset to factory
specifications.
1. Check oil level and fill if
needed.
2. Refer to Bleeding the
Hydraulic System.
1. Loosen Bleed Screw by some
rotations before operating
the log splitter.
2. Tighten the Bleed Screw up
before moving the log
splitter.
3. Tighten the Oil Drain Bolt
with Dipstick.
4. Check valve assembly and
seals. Replace either if
necessary.
8727679
17

Publicité

loading