Publicité
Les langues disponibles
Les langues disponibles
V4.1
4.
Refill the hydraulic oil reservoir by raising the front end until the tool is vertical.
Place supports around the tool if necessary. See Specifications for the proper
amount of hydraulic oil. A funnel may be needed depending on the angle.
5.
Bleed the hydraulic system.
6.
Clean the dipstick (O) and insert it back into the oil tank. Keep the log
splitter vertical. The oil level should be between the dipstick's two grooves.
Top the level up or drain depending on the result.
7.
Clean the area around the oil outlet.
8.
Clean the oil drain bolt's threads and screw it back into place. Tighten to
ensure it is sealed.
9.
Remove any supports and return the log splitter to the horizontal position.
BLEEDING THE HYDRAULIC SYSTEM
Bleed excess air from the hydraulic system as follows:
1.
Remove the oil filler screw and fill the cylinder with hydraulic fluid.
2.
Wait 5 minutes for trapped air to rise to the surface.
3.
Check the oil filler hole and if necessary, top off with more hydraulic oil.
4.
Restore the oil filler screw.
5.
Test the ram several times for proper operation before putting it into use. Do
not use the ram if it still does not appear to be working properly. Have a
qualified service technician service or repair the hydraulic system.
SHARPENING THE WEDGE
The wedge will dull after use. Sharpen the wedge's edge by removing burrs and
crushed areas with a fine-toothed file.
LUBRICATION
Inspect and lubricate the tool when required. Only use light oil to lubricate the
tool. Other lubricants may not be suitable and could damage the tool or cause a
malfunction during use.
NOTICE! NEVER use a penetrating oil to lubricate the tool. Penetrating oil
may act as a solvent that can break down the grease and cause the tool to
seize up.
Visit www.princessauto.com for more information
9 Ton Electric Log Splitter
8727679
15
Publicité
