Publicité
Les langues disponibles
Les langues disponibles
8727679
5.
Keep the tool handles clean, dry and free from oil/grease at all times.
6.
Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
HYDRAULIC RAM MAINTENANCE
Monthly maintenance is recommended for the hydraulic ram. Any restrictions due
to dirt, rust, etc. can cause the either slow movement or extremely rapid jerks,
damaging the internal components. The following steps are designed to keep the
cylinder maintained and operational.
1.
Lubricate the cylinder and ram with light oil.
2.
Visually inspect for cracked welds, bent, loose, missing parts or hydraulic
oil leaks.
3.
Inspect the hydraulic ram immediately if it was subjected to an abnormal load
or shock load.
4.
Remove any hydraulic cylinder from service that is damaged, worn down or
operates abnormally, until repaired by an authorized service technician.
5.
Check and maintain the ram oil level.
6.
Always store the hydraulic ram in the fully retracted position. This will help
protect critical areas from corrosion.
7.
Do not use brake or transmission fluids or regular motor oil as they can
damage the seals. Always purchase and use products labeled Hydraulic Oil.
REPLACING HYDRAULIC OIL
Replace the hydraulic oil after every 400 hours of tool use.
1.
Return the pusher to the starting position and shut the motor OFF. Unplug
the log splitter and allow time for the tool to cool down.
2.
Unscrew the oil drain plug (O) and set aside.
3.
Place an 8 litre container below the oil outlet, then tip the front end down
to allow the hydraulic oil to drain out. You may need to lift the rear end and
place a support under it.
14
9 Ton Electric Log Splitter
For technical questions call 1-800-665-8685
V4.1
Publicité
