Power Fist 8727679 Manuel De L'utilisateur page 13

V4.1
7. Push the lever into the second position (full) to split the log.
8. Release both controls and the pusher will return to the starting position.
9. Remove wood pieces from the splitter and clear debris from the
surrounding area. Return the work table to its starting position before
loading the next log.
FREEING A JAMMED LOG
WARNING! Do not attempt to remove a jammed log with your hands or with
hammer blows. The wood is under pressure and could separate and launch
without warning, causing an injury to you or a bystander.
A log may jam against the wedge without splitting. The following procedure can
free the log. The intent is to remove the jammed log without splitting it.
1. Release both controls and allow the log
pusher to return to the starting position.
2. Insert the narrow edge of a split log
wedge under the jammed log (Fig. 3).
3. Start the log splitter and push the split
log wedge under the wood. Release the
controls before the pusher touches the
jammed log.
4. Repeat the procedure with split log
wedges that have a steeper angle until the jammed log is freed. Remove
the prior split log wedge if possible.
5. Discard the jammed log and split it by another method.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
Visit www.princessauto.com for more information
9 Ton Electric Log Splitter 8727679
Fig. 3
13