Adjusting Screen; Install Cable Covers - PEERLESS Paramount PC930A Installation Et Montage

Adjusting Screen

If screws indicated are fully tightened, loosen screws half a turn to allow for adjusting tilt, swivel and roll. Adjust
9
screen to the desired position and fully tighten screws.
• Do not loosen adjustment screws to the point they become disengaged from the mount. Weight of the screen should
be supported in case of accidental disengagement.
ROLL ADJUSTMENT
BACK VIEW
SCREWS FOR ROLL
ADJUSTMENT
6° (±3°) ROLL

Install Cable Covers

Note: Be certain mount is in the desired
10
extended position.
Attach cables to screen if routed through
channels.
Cut cable covers (G) to the length of inner
channel (C) and outer channel (B) openings,
leaving space for cables if routed through
channels. Snap cable covers into openings as
shown.
Cables not routed through channels will require
cable ties (not included).
WARNING
TILT ADJUSTMENT
SIDE VIEW
SCREWS FOR TILT
ADJUSTMENT
(BOTH SIDES)
SLOT ALLOWS FOR
INCREMENTAL TILT
ADJUSTMENTS OF 5°
25° (+20°/-5°) TILT
CUT TO
LENGTH OF
OPENING
SWIVEL ADJUSTMENT
BOTTOM VIEW
SCREWS FOR SWIVEL ADJUSTMENT
90° (±45°) SWIVEL
G
C
B
G
CUT TO
LENGTH OF
OPENING