Adjusting Mount Extension - PEERLESS Paramount PC930A Installation Et Montage

Attaching Screen
Guide hook slots of tilt bracket (F) onto M5 x 10 mm screws (J) in swivel/pivot bracket (E) as shown in figure 7.1.
7
Thread two M5 x 10 mm screws (J) through tilt slot of tilt bracket (F) into swivel/pivot bracket (E) as shown in
figure 7.2. Do not fully tighten screws to allow for tilt adjustments. Tilt slot allows for incremental tilts of 5°.
Adjust tilt of screen and fully tighten all four M5 x 10 mm screws (J) as shown in figure 7.3.
• Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely
handle placement of the screen.
fig. 7.1
F
SLOTS

Adjusting Mount Extension

While supporting the weight of the screen, loosen
8
screws (L) on clamp plate (D) half a turn and
position screen to the desired height.
Retighten clamp plate screws securely.
WARNING
• Clamp plate adjustment screws support weight of
screen when fully tightened. Weight of the screen will
need to be supported if clamp plate screws are
loosened.
SLOTS
J
HOOK
E
WARNING
TILT
F
J
fig. 7.2
L
CLAMP PLATE
SCREWS
fig. 7.3
E
D
J