Installation Instructions - Zanussi ZVT860X Notice D'utilisation

Problem
The sensor fields become hot.
comes on.
comes on.
and a number come on.
If you tried the above solutions and cannot re-
pair the problem, speak to your dealer or the
customer service. Give the data from the rating
plate, three digit letter code for the glass ce-
ramic (it is in the corner of the glass surface)
and an error message that comes on.

Installation instructions

Warning! Refer to "Safety information"
chapter.
Before the installation
Before the installation of the appliance, record
the information below from the rating plate. The
rating plate is on the bottom of the appliance
casing.
• Model ...........................
• PNC .............................
• Serial number ....................
www.zanussi.com
Possible cause
The cookware is too large or you
put it too near to the controls.
The Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
There is an error in the appliance.
Make sure, you operated the appliance correct-
ly. If not the servicing by a customer service
technician or dealer will not be free of charge,
also during the warranty period. The instruc-
tions about the customer service and condi-
tions of guarantee are in the guarantee booklet.
Built-in appliances
• Only use the built-in appliances after you as-
Connection cable
• The appliance is supplied with the connec-
• Replace the damaged mains cable with a
Put large cookware on the rear
cooking zones if necessary.
Deactivate the appliance and acti-
vate it again.
Refer to the chapter "Daily use".
Disconnect the appliance from the
electrical supply for some time.
Disconnect the fuse from the elec-
trical system of the house. Connect
it again. If
speak to the service centre.
semble the appliance into correct built-in
units and work surfaces that align to the
standards.
tion cable.
special cable (type H05BB-F Tmax 90°C; or
higher). Speak to your local Service Centre.
Remedy
comes on again,
23