Putting Into Operation; Electric Shock - Abicor Binzel iROB Cool Mode D'emploi

6 Putting into operation

6 Putting into operation
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
Risk of injury
Limbs can be crushed and sheared.
• Use appropriate lifting tool with load handling devices for transport and installation.
NOTICE
• Please take note of the following instructions:
• The system may only be installed and put into operation by authorized personnel
• Components must only be used in environments with sufficient ventilation.
• The interconnection (serial or parallel connection) of several coolant recirculators can result in
• Make sure that the coolant recirculator is filled with cooling liquid before putting into operation.
• The cooling pump shall not under any circumstances run dry, as this will destroy the pump and render
EN - 10
DANGER
WARNING
WARNING
 3 Product description on page EN-6
(in Germany see TRBS 1203).
material damage.
the warranty invalid.
iROB Cool
BAL.0332.0 • 2017-08-31