Power Fist 8900797 Manuel D'utilisation page 12

8900797
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
The chipper does
not draw in
material.
Uneven chip size.
Discharge opening
is blocked.
Excessive Vibration. 1. Loose parts or
Unit does not
discharge.
Rate of discharge
slows considerably
or composition of
discharged material
changes.
12
6.5 HP 208cc Wood Chipper
Possible Cause(s)
1. Dull knives.
2. Knives cutting angle is
wrong.
3. Knives fitted wrong
way.
1. Knife gap too large.
2. Single length of wood
turned sideways.
1. RPM too low.
damaged
drum/blades.
2. Excessive ingoing
material.
1. Chute clogged.
2. Foreign object lodged
in drum or hopper.
3. Low engine RPM.
1. Low engine RPM.
2. Chipper blade dull.
Suggested Solution(s)
1. Sharpen or replace knives.
2. Reposition knives.
3. Reposition knives.
1. Adjust knives.
2. Remove wood if needed.
1. Increase engine RPM.
1. Stop engine and allow to cool.
Inspect drum and blade and
tighten any loose parts.
2. Reduce speed material is fed
into hopper.
1. Stop engine and allow to cool.
Clean the discharge chute.
2. Stop engine and allow to cool.
Remove lodged object.
3. Increase engine RPM.
1. Increase engine RPM.
2. Sharpen or replace blades.
For technical questions call 1-800-665-8685
V1.0