Power Fist 8900797 Manuel D'utilisation page 10

8900797
CHIPPER IS JAMMED
DANGER! Never attempt to unblock the machine whilst the chipper is
running. The active chipper blades will cause a severe wound, amputation
or death. Shut off the chipper before attempting to remove a blockage.
1. If the drum stops while chipping, stop the engine immediately.
2. Unhinge either the feed hopper (#1) or discharge chute (#33) by
loosening the bolt on the bottom of chute and lifting it upward to allow
access to the drum. Remove wood or branches that are blocking the
drum. Reconnect the hopper or chute, then restart the engine. Listen for
any sounds that indicates there is still a blockage.
3. Some wood or branches cannot be easily removed by hand. On the drum
side of the chipper, remove the end cap (#24) with a flathead screwdriver
(Fig. 6). There is a
nut under the cap
that can be turned
(with the appropriate
socket) to rotate the
drum in reverse.
Remove the
blockage, then reseal
the nut and reset the
chute and hopper.
CARE & MAINTENANCE
Consult the engine manual for engine care and maintenance.
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
10
6.5 HP 208cc Wood Chipper
For technical questions call 1-800-665-8685
V1.0
Fig. 6