Electrical Connection; Operation; Switching On - Kerbl HAPPYCOW Duo Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
Figure 5: Removal of the transport safety screw

5.4 Electrical connection

Important!
If the unit is fuse-protected with one or more large consumers, functional faults and damage can occur to the electronics!
• The unit must be connected to the voltage and frequency specified on the rating plate.
• To connect the unit, a 16 A AC socket must be installed. This must be installed out of the animals' reach (above the unit).
• The manufacturer accepts no responsibility and offers no guarantee for any damage caused by connections not set up by trained professionals.
• Local safety and earthing requirements must be observed. Ask your electrician!

6. Operation

Caution!
• The dip switch setting may only be made by a qualified electrician following consultation with Kerbl Service.
The unit must be disconnected from the voltage supply for this to be done.
• The dip switch setting is coordinated with this unit. If the default setting is changed, injuries can occur.
The responsibility for this setting lies with the customer.

6.1 Switching on

Once the power supply is connected, the unit is ready for operation after around 20 seconds. The unit indicates its readiness for operation by dis-
playing 3 lines in the display (see fig. 7). Before that, the display shows the following:
• dIP – followed by the current dip switch setting, e.g. 16 A,
• APP – followed by the current software version, e.g. 1.18,
(for further information, see Point 6.3. Display and electronics).
Figure 6: Cable length A-B = 55 cm, sensor distance 8 - 10 mm
Albert KERBL GmbH
Felizenzell 9
D-84428 Buchbach
l
l
Fon +49 (0)8086 - 933-100
Fax +49 (0)8086 - 933-500
l
Mail info@kerbl.com
www.kerbl.com
l
DATE
STAT. REVISION NOTE
44
FINISHED SURFACE:
ISO 5456-2 Projection
methode1
WEIGHT IN GRAMM
General tolerances
(WITHOUT FINISHED SURFACE):
ISO 2768 - mK
156693,915 g
DATE
NAME
sreinthaler
DRAW
22.6.2021
CHECK
NORM
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
ARTICLE NUMBER
PROJECT NUMBER
Figure 7
KERBL:
KERBL:
18820
700103
NAME Urspr.
Figure 4:
Mounting of the ventilation
screw
STAT. REVISION
1:50
SCALE
MATERIAL:
TITLE:
Kuhkratzbürste - Zusammenbau Versio
Baugruppe / Assembly
DWG NO.
26960
Albert KE
Fon +49 (
M
DET
BAS

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1881018820

Table des Matières