Figure 1; Description; Description Of The Unit; Scope Of Delivery - Kerbl HAPPYCOW Duo Mode D'emploi

4. Description

4.1 Description of the unit

Electric cattle brush model: HAPPYCOW Duo
The units are designed to hygienically clean the hide of cattle and at the same time reduce costs compared to traditional cleaning by hand.
• Units with type "18820" and "18820-E" comply with the applicable safety regulations for persons and property according to the EU Machinery
Directive, see EU Declaration of Conformity.
• Units with type "18820-E" comply with the applicable safety regulations for persons and property according to the Supply of Machinery (Safety)
Regulations 2008, see UK - Declaration of Conformity.
Use of these units can cause danger to the life and limb of the user or third parties, or damage to the unit or other material assets.
Caution!
The unit must be used exclusively in accordance with intended use and in a technically safe condition!
The operational safety of the unit is only guaranteed if it is used for its intended purpose. Failure to comply with the individually listed points in
the operating instructions can result in physical injury or material damage for which the manufacturer assumes no liability.

4.2 Scope of delivery

• Brush unit and pre-mounted control unit
• Ventilation screw for gears
• Operating instructions

4.3 Correct use

This unit must only be used for the dry cleaning of female cattle in pens. The collars of the cattle must fit tightly and the tail hair must be kept
short (< 5 cm). The animals' hide hair must also not be longer than 5 cm. The unit can be operated with a maximum of 60 animals.
The regulations set out in these operating instructions must be complied with. Any other use of the unit, e.g. in any other area than those de-
scribed, shall be deemed incorrect use. The manufacturer accepts no
liability for any resulting physical and/or material damage.

4.4 Technical data

Article number / type designation: 18820, 18820-E
Voltage:
Output:
Speed:
Protection type:
Protection class:
Dimensions:
Fastening drill hole distance:
Weight:
Brush diameter:
Brush length:

4.5 Conversions or modifications

In the event of unauthorised conversions and modifications to the
unit, any liability and warranty on the part of the manufacturer will be
rendered void.
Conversions and modifications may only be carried out with the writ-
ten consent of the manufacturer.
1. Control unit
2. Motor gear unit
3. Ventilation screw
4. Brush, horizontal
5. Sensor
6. Carriage
230 V / 50 Hz
0.37 kW
60 rpm
IP 56
I
H 1150 x W 400 x D 1050 mm
Figure 3
approx. 150 kg
315 mm and 420 mm diameter
650 / 550 mm
7. Fastening frame
8. Safety panel, carriage
9. Safety panel, lateral
10. Brush, vertical
11. Transport safety screw
2
3
4
10

Figure 1:

Description of the unit
41
1
5
6
7
8
9
11