Settings In The Menu - ACO LipuSmart-P Serie Manuel D'utilisation

4.2.2 Settings in the menu

Settings in several menu items can only be made in Service mode and should be agreed with ACO
Service.
Run time and pump cycles can be displayed but not changed.
■
■
Explanation of the menu items
Menu items
(top line)
Baseload ON
Baseload OFF
High water level
Run. Time max.
Run time altern.
Settings
Explanation
(bottom line)
0 – 200 cm
0 – 200 cm
0 – 200 cm Activation point for additional pump
0 – 200 cm
0 – 200 cm High water level alarm if exceeded
automatically after the set stop delay.
0 – 60 min
The pump does not start up again until the defect
The pump changeover is after the set time in the
basic load mode. After three changes without
deactivated
interruption the High water level alarm is also
1 – 60 min
appears in the display.
0 – 900 s not start until the set time has expired. The remaining
time is shown in the display.
LipuSmart-P
Operation
87