Cooke & Lewis CLVH60W-C Mode D'emploi page 45

09
[02]
B
A
A
x4
MOUNTING THE HOOD UNDERNEATH A CUPBOARD
Both extraction and recirculation options can be used
EXTRACTION
Cut a hole in the cupboard base to suit the position of the exhaust vent in the visor
hood and size to suit the vent kit being used.
Connect collar [02] this is used to connect to vent kit.
Using 4 suitable length screws attach the cooker hood to the underside of the
cupboard using the 2 hole position (A) and 2 hole position (B).
Connect vent kit as per manufactuers instructions
Important: The exhaust air must not be expelled through a smoke or waste gas
chimney, which is in use,or through a shaft used for ventilating rooms or into the cavity
of a wall.
RECIRCULATION
Connect blanking plate (05) and secure it by 2 screws (6)
Using 4 suitable length screws attach the visor hood to the underside of the cupboard
using the 2 hole position (A) and 2 hole position (B).
Ensure correct recirculation filters are fitted, please refer to Care and maintenance
section
:
Important If the room contains a fuel burning appliance, such as a gas, or oil fired,
central heating boiler, which is not of the 'Balanced Flue' type, you should make sure
that there is adequate air inlet into the room at all times so that fumes from the boiler
are not drawn back into the room by the Cooker Hood.
For electrical connection see Technical and legal information section.
45