Safety Instructions - Dustcontrol S 11000 EX Traduction Des Instructions De Service D'origine

Safety Instructions

Read the following Safety Instructions before starting this unit. Save the User Guide for future reference. Failure to comply with
the Safety Instructions voids the warranty and may result in personal injury and damage to the product. Dustcontrol is not
responsible for damage to the equipment caused by improper installation or improper operation of the equipment.
Warning
This unit is intended for professional use only.
Use only original accessories and consumables that are included in Dustcontrol's range.
WARNING
Use the product for its intended purpose. Follow the instructions for the material to be extracted. See the local
risk assessment document produced by the factory owner.
WARNING
If incorrect or non-OEM parts are used (especially filters, hoses and plastic bags), the machine can leak
hazardous dust which may result in personal injury.
WARNING
ATEX: The product must not absorb explosive, unstable or self-igniting particles. The minimum ignition energy
(MIE) of the material must exceed 3 mJ.
Environmental protection
Recycle packaging and components according to local regulations. For more information, contact your nearest recycling center.
Work area environment
The space in direct connection to the unit must be kept clean. Do not store or handle flammable liquids or gases near the unit.
Dustcontrol recommends that ATEX cyclones be placed outdoors. Safety distances to the explosion panel can be found in a
separate document from the supplier.
Only use accessories approved by the manufacturer for use in Zone 22. The use of other accessories may cause an explosion.
Only antistatic or metal suction accessories may be used.
Overload
In the event of an alarm indication, do not restart the unit until the cause of the fault has been detected and the error rectified.
Bodily injuries
Warning for strong negative pressure! Never start the unit until it is properly connected to the piping system.
WARNING
Protective gloves must be worn when assembling, handling and transporting the product.
Important safety precaution
Thisunit must only be used if all filters are intact and properly fitted.
Before performing any work on the unit or connected piping system, the main power supply to the unit must be disconnected and
in cases where a device has no integrated electrical cabinet, the power switch must be locked.
Always carry out a filter cleaning and empty the compressed air tank before detaching the collection device from the filter unit. All
handling of the collected material must comply with the relevant regulations.
S 11000 EX, Art no. 99058-A 13