Dustbane Hurricane 700 XTT Mode D'emploi page 19

To recharge proceed as follows:
• Stop the machine and press the emergency button (fig. 8, ref. 2);
• Engage the parking brake by means of the pedal (fig. 8, ref. 12);
• Connect the battery-charger to the battery wiring connector (fig 17, ref. 1);
• Recharge according to the instructions written in the manual to the battery-charger;
• Switch off the battery charger before disconnecting the connectors;
• Disconnect the battery charger connector from the battery wiring connector;
• If using Flooded Lead Acid batteries, at the end of the recharging time check the battery intensity with a densimeter: if
one or more elements are flat and the remaining ones completely charged, the battery is damaged and must be replaced.
MAINTENANCE INSTRUCTIONS
! DANGER: Never perform any maintenance operations without first disconnecting the batteries. Maintenance on the electrical circuit and
all other operations not explicitly described in this manual must be performed by specialized personnel only, in compliance with current
safety legislation and as described in the maintenance manual.
! DANGER: Before lifting/rotating the tank to access the compartment, its contents must first be emptied, then insert the safety bracket in
position to prevent the tank from accidentally closing again, see chapter "SAFETY INFORMATION".
Maintenance - General rules
Performing regular maintenance according to the Manufacturer's instructions improves performance and extends the working life
of the machine.
When cleaning the machine, observe the following precautions:
• Avoid using pressure washers. Water could penetrate the electrical compartment or motors leading to damage or short
circuits.
• Do not use steam to avoid the heat warping plastic parts.
• Do not use solvents or hydrocarbon based products. These can damage the cowling and rubber components.
Suction Air Filter And Floating Rod: Cleaning
• Stop the machine and press the emergency button (fig. 8, ref. 2); engage the parking brake by means of the pedal
(fig. 8, ref. 12);
• Open the recover tank lid (fig. 18, ref. 1);
• Make sure that the recovery tank (fig. 18, ref. 4) is empty;
• Take out the air filter (fig. 18, ref. 2) of the suction unit from the float support (fig. 18, ref. 3), which is located on the upper
inner side of the recovery tank;
• Clean the filter with current water or with the detergent used in the machine;
• Put the filter back in the support only after having it dried well;
• Make sure that the filter has been replaced in its seat correctly;
• Check that the floating rod (fig. 18, ref. 5), which is also fixed to the support
(fig. 18, ref. 3), moves freely and clean it;
• Close the recovery tank lid.;
Operations Manual Hurricane 700 XTT / Hurricane 850 XTT
19