Dustbane Hurricane 700 XTT Mode D'emploi page 10

Batteries: installation and connection
! DANGER: Remove the electronic key from the instrument panel before installing and connecting the batteries. Make sure you connect
the terminals marked with a "+" to the positive poles of the battery. Do not check the battery charge by sparking.
Meticulously follow the instructions given below as short circuiting the batteries could cause them to explode.
• Stop the machine and press the emergency button (fig. 8, ref. 2); engage the parking brake by means of the pedal (fig. 8,
ref. 12);
• Make sure that the two tanks are empty (empty them, if necessary: see respective paragraph);
• Unhook the recovery tank (fig. 2, ref. 2) from the solution tank (fig. 2, ref. 3) acting on the blocking hook (fig. 7, ref. 1),
placed on front of the machine;
• Lift the recovery tank, by making it turn backwards around about 90°: in this way you have access to the battery
compartment (embedded in the solution tank) from the upper side;
• Insert the batteries in the compartment, orienting them as shown in the drawing printed on the solution tank in the
compartment.Install the storage batteries on the machine using suitable means according to their weight. Positive and
negative poles have different diameters.
• Referring to the arrangement of cables in the aforesaid drawing, connect the clips of the battery wiring and the bridge to
the poles of the storage batteries. After orienting the cables as shown in the drawing, tighten the clips at the poles and
cover them with vaseline;
• Insert back the tank unit in its work position and hook it to the solution tank by means of the fixing hook (fig. 7, ref. 1);
• Use the machine in compliance with the instructions written below.
Batteries: removal
Make sure the switches on the control panel are in the "0" position (off ) and the machine is turned off. Keep away from naked
flames, do not short circuit the battery poles, do not cause sparks and do not smoke. Proceed as follows:
• Disconnect the battery wiring and bridge terminals from the battery poles.
• If necessary, remove the devices fixing the battery to the base of the machine.
• Lift the batteries from the compartment using suitable lifting equipment.
10
Operations Manual Hurricane 700 XTT / Hurricane 850 XTT