Dustbane Hurricane 700 XTT Mode D'emploi page 14

Flap adjustment
• Loosen the screws (fig. 13, ref. 1);
• Position the flap blade (fig. 13, ref. 2) so that it adheres perfectly to the floor;
• Retighten the screws.
Detergents – Instructions
! INFORMATION: Always dilute the detergent according to the manufacturer's instructions. Do not use bleach or other oxidants, particu-
larly in strong concentrations. Do not use solvents or hydrocarbons. The temperature of the water and detergent must not exceed the
maximum indicated in the technical specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made specifically
for automatic scrubbers. For a complete and up-to-date list of the detergents and chemicals available, contact the manufacturer.
Use products suitable for the floor and dirt to be removed only. Follow the safety regulations
on use of detergents given in the section "Safety regulations".
Setting Up The Machine
Before starting to work wear an apron, cap, non-slip waterproof shoes, a mask to protect the respiratory system, gloves and any other
form of protection indicated by the supplier of the detergent or necessary in the environment you are going to work in.
Before starting to work, perform the following operations:
• Check the level of battery charge (recharge, if necessary);
• Disengage the parking brake via the pedal (fig. 8, ref. 12);
• Make sure that the recovery tank (fig. 2, ref. 2) is empty; if this is not so, empty it;
• Check that the water control lever (fig. 8, ref. 3) is at the position "off";
• Fill the solution tank (fig. 2, ref. 3) through the respective hole on the front with clean water and non-foaming detergent
in a suitable concentration: leave a difference in level of at least 5 cm between the liquid surface and the tank opening;
• Install brushes or pad drivers suitable for the floor and the job to be done;
• Lower the head by pressing the brush up-down button (fig. 8, ref. 5) on the arrow down;
• Check that the squeegee (fig. 2, ref. 8) is fixed well and connected to the suction tube (fig. 9, ref. 4); make sure that the rear
blade is not worn.
14
Operations Manual Hurricane 700 XTT / Hurricane 850 XTT