Dustbane Hurricane 700 XTT Mode D'emploi page 15

If you use the machine for the first time, it is advisable that you train with it for a short time on a wide surface without any obstacles, to
acquire the necessary familiarity. Always empty the recovery tank before refilling the solution tank.
For an effective cleaning and long life of the equipment, it is necessary to follow some simple rules:
• Prepare the work area, keeping away the possible obstacles;
• Begin to work starting from the farthest spot, in order to avoid trampling on the area just-cleaned;
• Choose paths that are as much straight as possible;
• On wide floors divide the paths into rectangular and parallel areas.
At the end quickly mop the area, if necessary, to clean spots that are inaccessible to the scrubber.
Work
After setting up the machine, proceed as follows:
• Insert and operate the key to release the main switch (fig. 8, ref. 2) and enable all the machine functions: the battery
charge level indicator will come on (fig. 8, ref. 9);
• Move the lever (fig. 8, ref. 3) to the position of minimum flow of solution: the detergent solution begins to reach the
brushes;
• Press the brush/roller up-down button (fig. 8, ref. 5) on the arrow down: the head will begin to move down and as soon
as the brushes touch the floor the brush motors will come on. As the brushes rotate, the solution is distributed over the
floor;
• Lower the squeegee by means of the proper lever (fig. 8, ref. 11): the suction motor comes on;
• Press the drive lever (fig. 8, ref. 6) placed under the handgrip: the drive motor is started and the machine starts moving
forward;
• Adjust the running speed via the potentiometer (fig. 8, ref. 1);
• If you wish to engage reverse gear during work with the squeegee lowered, you must first stop and raise the squeegee;
• Check periodically that the detergent solution reaches the brushes/rollers and fill with solution if it runs out;
• Check cleaning quality during work and adjust, as required, the flow of solution sent to the brushes/rollers (by rotating
the cursor (fig. 8, ref. 3)) and the pressure exerted by the head-brushes on the floor (via the brush up-down button (fig. 8,
ref. 5) until the test pressure indicator (fig. 8, ref. 8) indicates the required level).
In working conditions, if the emergency switch is accidentally pressed and the machine is switched off, when it is switched on again the
brush button must be pressed to re-activate the brushes. Never leave the machine stationary with the head lowered and the brushes in
motion: the floor could be damaged. Whenever you fill up the solution tank, always empty the recovery tank. Do not leave the machine
stationary with the suction motor on and the solution cock turned on.
• If the warning led (fig. 8, ref. 9) starts flashing, it means that the storage batteries are getting flat. Therefore, it is necessary
to recharge them; if you keep on working, the batteries could become damaged irreparably;
• If the suction unit revs up but does not perform suction, it means that the floater has cut in. In this case the recovery tank
must be emptied (see specific paragraph).
If for any reason the battery voltage drops considerably below the level envisaged, even temporarily, the drive lock may cut in. In this case
the machine must be switched off and then on again.
Operations Manual Hurricane 700 XTT / Hurricane 850 XTT
15