Attaching The Tube Rings - Omegon EQ-1 Mode D'emploi

Telescope assembly
2.3 Installing the counterweight
1. A counterweight and a counterweight shaft are included in delivery.
2. Take the counterweight shaft and insert it into the threaded socket provided for it in the mount.
3. Remove the small locking screw at the end of the shaft and push the counterweight onto the shaft.
Then tighten the screw on the counterweight so that it is no longer able to slide on its shaft.
4. Replace the locking screw

2.4 Attaching the tube rings

1. Remove the tube rings from your telescope tube by loosening the locking screws.
2. Offer up the tube rings onto the mount's mounting rail. You will see two holes, which are intended for the
screws. Using the appropriate screwdriver, permanently fasten the tube rings onto the mount. After
attaching, ensure that both tube ring locking screws are pointing in the same direction.
53