Publicité
Les langues disponibles
Les langues disponibles
All the above settings for temperature, time, date, week and programs remain in effect until the electrical power
is not turned off.
In case of power failure:
-After the heater is reconnected to power, it will enter into Standby mode. You can press the
enter into the mode and temperature before power interruption.
-The machine stays in memory only the parameter, temperature and thermostat mode. When power is
restored, the clock will be adjusted again to make the various programs run correctly P1/P2/P3/Personalized.
IN CASE OF PROBLEMS
Problem
The device does not heat
The heater keeps heating
MAINTENANCE
1. Always disconnect the appliance and let it
completely cool before any maintenance.
2. Use a vacuum cleaner to remove dust on grilles.
3. Clean the outside of the unit with a damp cloth and
then dry it with a dry cloth. Never immerse the unit
in water, nor let water drip into the unit.
RECYCLING (DISPOSAL OF THE PRODUCT AT THE END OF ITS LIFE
The crossed-out wheeled bin symbol indicates that the item should be disposed of
separately from household waste. The item should be handed in for recycling in
accordance with local environmental regulations for waste disposal. By separating a
marked item from household waste, you will help reduce the volume of waste sent to
incinerators or land-fill and minimize any potential negative impact on human health
and the environment.
REGULATIONS
In accordance with Commission Regulation (EU) 2015/1188 of 28 April 2015 implementing
Solution
Check the circuit breakers are on and the load- shedding
device has not cut the power supply (if the installation has
one).
Select the COMFORT mode.
Increase the temperature.
Check the device is not in an air current.
Decrease the temperature.
19
button to
Publicité
