Stanley SPT-163-560 Traduction De La Notice Originale page 9

6. Assembly
Following the assembly directions below, you will
assemble the snow thrower in a few minutes
Engine
1. Remove wing nut and washer from the air
filter cover.
2. Rotate the air filter cover by 180o so that
the primer faces outside.
3. Install air filter cover and tighten wing nut.
Handlebars
1. Remove the axle pin and slide the wheel on the
axle. Insert the axle pin through the hole in the
wheel hub and through the hole in the axle.
2. Align the holes in the handlebars with the side
plates and secure handlebars with the screws and
the washers until they are finger tight.
3. Secure control panel to the handlebars with
screws, washers and nuts until they are
finger tight.
4. Ensure that the handles are at the same
height, and then tighten all the fasteners
securely.
9
G
B