Télécharger Imprimer la page

Stanley SPT-163-560 Traduction De La Notice Originale page 27

Masquer les pouces Voir aussi pour SPT-163-560:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 83
11. TROUBLE SHOOTING
Problem
Electric starter does not
turn(on models so equipped)
Engine fails to start
Engine idles or runs
roughly
The engine overheats
Excessive vibration
Cause
1. Extension cord not connected.
2. The extension cord is worn,
corroded, or damaged.
3.The power outlet is not energized.
1. Choke not in CHOKE position.
2.Engine not primed.
3.Engine is flooded.
4.Fuel shut-off valve closed.
5. Throttle in STOP position or ON/
OFF switch is OFF.
6. Spark plug wire loose or
disconnected.
7.Fuel tank empty or stale fuel.
8.Faulty spark plug.
9.Safety ignition key is not inserted.
10. The engine oil level in the engine
crankcase is too low or too high
1. Engine running on CHOKE.
2. Fuel tank is nearly empty or stale
fuel.
3.Contaminated fuel supply.
4.Carburetor out of adjustment.
5.Engine over-governed.
6. The fuel shutoff valve is not
completely open or blockage in
fuel line.
7.Spark plug wire loose.
8.Faulty spark plug.
9. The engine oil level in the engine
crankcase is too low or too high.
Carburetor not adjusted properly.
Loose parts or damaged parts.
27
Remedy
1. Connect the extension cord to
the outlet and/or the machine.
2.Replace the extension cord.
3. Have a qualified electrician
energize the outlet.
1. Move choke to CHOKE position.
2. Prime engine as instructed in
this manual.
3. Wait a few minutes before
restarting, do not prime.
4.Open fuel shut-off valve.
5. Move throttle to FAST position
or ON/OFF switch to ON Position.
6. Connect or tighten spark plug
wire.
7. Fill tank with clean, fresh
gasoline.
8. Clean, adjust gap, or replace.
9. Insert safety ignition key.
10. Add or drain oil to adjust the oil
level in the engine crankcase.
1. Move choke lever to RUN
position.
2. Fill tank with clean, fresh
gasoline.
3. Replace with clean fuel.
4 . Contact a qualified repair
personnel.
5. Contact a qualified repair
personnel.
6. Open the fuel shutoff valve or
clean fuel line.
7. Tighten spark plug wire.
8. Clean, adjust gap, or replace.
9. Add or drain oil to adjust the oil
level in the engine crankcase.
Contact a qualified repair
personnel.
Tighten all fasteners or replace
damaged parts.
G
B

Publicité

loading