Publicité
Les langues disponibles
Les langues disponibles
G
B
is released and in the disengaged position, the
cable should have very little slack.
Auger must stop within 5 seconds when the
auger clutch lever is released. If auger clutch
does not engage or disengage properly, adjust
auger clutch before operation.
If the snow thrower's drive is disengaging
intermittently during operation, or it drives
when you release the drive clutch lever, adjust
the drive clutch before operation.
Both auger clutch and drive clutch can be
adjusted as follows:
1. Loosen jam nut on adjustment turnbuckle.
Turn the adjustment turnbuckle up and
down to increase cable tension or provide
more slack.
2. Retighten jam nut.
Chute Bracket
If the spiral at the bottom of the chute crank
lever is not fully engaging with the chute
assembly, the chute bracket can be adjusted.
To do so:
1. Loose the two nuts which secure the chute
bracket and reposition it slightly.
2. Retighten the nuts.
Freewheeling and Self-Propelling
Use the axle lock pin to lock or unlock the
right or left wheel. Lock both wheels to
increase traction; unlock one wheel to allow
for easier turning of the unit; unlock both
wheels for freewheeling.
18
Publicité
