Recorder Setup; Record Schedule; Motion Detection Sensitivity - SCS Sentinel DWS Manuel D'installation Et D'utilisation

RECORDER SETUP

Record Schedule

Audio is available for one channel only, even when performing QUAD record. By default
audio is set for channel 1, but when system is performing motion triggered recording,
audio will automatically switch to the channel triggered therefore during playback you
will only hear the audio recorded from the channel triggered by motion.
System can perform recording function 30 seconds after powered up. Recording cannot
be stopped until 30 seconds after recording start.
To stop recording process, press REC/DEL once. System will continue with motion or
schedule recording 60 seconds after the previous recording session ended MANUALLY.
Menu control functions are disabled while system is in recording mode. Receiver cannot
perform recording function if Memory Card is not inserted. System will resume QUAD
mode after idling for two minutes.

Motion Detection Sensitivity

1. Select RECORDER SETUP, press the MENU button to
enter sub-menu.
2. Use ▼▲ to select the sub menu [RECORD
SCHEDULE] [MOTION DETECTION SENSITIVITY]
[FORMAT STORAGE] [SETUP MASKING AREA] [MOTION
RECORD TIME]
There are three different recording options available
to choose from.
1. Highlight the time period and press MENU.
2. Switch between different recording modes.
M: MOTION (REC only when triggered) S: SCHEDULE
(continuous REC)
C: MANUAL (manual REC)
3. The system will record all 4 channels simul-
taneously with MOTION, SCHEDULE
and MANUAL recording.
1. Use ▲▼ to select MOTION DETECTION SENSITIVITY section
2. Use ◄► to highlight camera for setup
3. Use ▲▼ to adjust sensitivity level: OFF / LV1 / LV2 / LV3
(LV3 is most sensitive)
4. Press ESC to save and exit.
- 43 -
EN