Safety And Installation Tips - SCS Sentinel DWS Manuel D'installation Et D'utilisation

SAFETY AND INSTALLATION TIPS

FOR RECEIVER:
•
Keep away from heat sources and high temperature places
•
Avoid direct sunlight
•
Avoid humid places
•
Avoid vibration
•
Install in a ventilated environment
FOR CAMERA(S) AND RECEIVER:
Do not attempt to open the units with the power adaptor plug connected to avoid any
risk of personal injury.
When installing CCTV camera(s), always follow manufacturer's advice when using power
tools, steps, ladders, etc. and wear suitable protective equipment (e.g. safety goggles)
when drilling holes. Before drilling holes through walls, check for hidden electricity cables
and water pipes. The use of cable/pipe detector is advisable.
It is also advisable to avoid exposing any cameras to extreme weather conditions (e.g,
under a gutter which is prone to any water leaks). When installing any cameras with this
unit, it is advisable to use cable conduit to protect any video/power extension cables
from being exposed externally and to prevent/reduce the chances of the cables being
tampered with. After drilling any hole though an external wall for a cable, ensure the hole
is sealed up around the cable using a sealant to prevent drafts.
To prevent a fi re or electrical shock hazard, do not attempt to open the housing while the
unit is exposed to rain, water or wet conditions. There are no user serviceable parts inside.
Refer servicing to qualifi ed service personnel. Avoid pointing the camera(s) directly at the
sun or any bushes, tree branches or moving objects that might unnecessarily cause the
receiver to record due to winds for example. System also provides the «Masking» function.
User may screen out motion detection area in parts of the picture which motion detection
is not required.
- 35 -
EN