Night Vision; Camera Installation; Setting The Camera Channel (Optional) - SCS Sentinel DWS Manuel D'installation Et D'utilisation

EN

NIGHT VISION

The camera has built-in infra-red LEDs to allow you to view at night for 24hrs surveillance. The LEDs
will automatically activate at night and the picture viewed will turn to black and white. The night
viewing range is up to 7 meters.

CAMERA INSTALLATION

•
Avoid positioning the camera so that it is facing directly at the sun as this will impair the
picture quality viewed.
•
Avoid pointing the camera lens directly through clear glass as the night vision LEDs will cause
a blurred image at night.
•
Avoid pointing the camera directly at any bushes, tree branches or moving objects that
might naturally move due to winds. This is also because if you need to use the motion
detection feature in the PC software to record movement the software might record
unnecessarily.

SETTING THE CAMERA CHANNEL (OPTIONAL)

The wireless camera is supplied preset to channel 1.
The monitor supports up to 4 cameras. Follow the steps below in Camera Setup section to setup
or change the monitor channel of the camera. If you are adding another camera to link with
the supplied monitor in this kit, then ensure its channel is set to a different channel to the existing
camera(s).
Secure camera stand on the wall
Loosen up the Thumb screw
Adjust proper view angle then secure the joint with
T-bolt.
- 36 -