Camera Pairing; Camera Brightness Adjustment; Camera Activation - SCS Sentinel DWS Manuel D'installation Et D'utilisation

EN

Camera Pairing

The System will confirm pairing process to be successful with «PAIRED» displaying on
screen, and indicate pairing process failed with «PAIRING FAIL.» Repeat the camera
pairing process if you want to add more cameras to the receiver.
3. Press ESC to return to MAIN MENU or press ▼▲ to select another camera to continue
the camera pairing process.

Camera Brightness Adjustment

Camera Activation

Your camera is paired to the monitor at the
factory to channel 1.
To add new camera(s) to your system, you
have to pair it to the different channel(s).
1. With the PAIRING option highlighted,
press the MENU button once to begin
camera pairing.
2. The pair LED on camera will blink once
and following with LED blinking continuously
to indicate data transmission in progress.
Press and release the pairing button on the
camera once quickly.
1. With IMAGE RIGHTNESS option highlighted,
use ▼▲ to adjust camera brightness
from OFF, LOW, MEDIUM to HIGH. Press the
MENU button once to confirm.
2. Press ESC to return to MAIN MENU or press
▼▲ to select another camera.
1. With ACTIVATION option highlighted, use
▼▲ to enable or disable the camera(s).
Press the MENU button once to confirm.
2. Press ESC to return to MAIN MENU or press
▼▲ to select another camera.
NOTE: Make sure camera(s) paired is enabled
for SCAN or QUAD to function properly
(camera «ON» can only be selected when
camera has been paired to system.).
- 42 -