Pairing The Camera To Receiver (Optional) - SCS Sentinel DWS Manuel D'installation Et D'utilisation

EN

PAIRING THE CAMERA TO RECEIVER (OPTIONAL)

Follow the steps in Camera Setup section to setup or change the channel of the camera. If you
are adding another camera to link with the supplied monitor in this kit, then ensure its channel is
set to a different channel to the existing camera(s).
Note :
If the camera is located within 1m to 1.5m from the monitor and the camera's volume on the
receiver is turned on, then you may hear a whistling noise on the monitor which is the feedback
picked up by the microphone. In this case please locate the camera further away from the
monitor to prevent this noise.
If the power connection to the camera is kept outdoors, ensure the connection is suitably
protected.
QUICK START GUIDE
- 37 -