Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Before attempting to service or troubleshoot the generator, the owner or service technician must first read the owner's
manual and understand and follow all safety instructions. Failure to follow all instructions may result in conditions that can
lead to voiding of the EPA certification or product warranty, serious personal injury, property damage or even death.
PROBLEM
Engine is running, but no
electrical output
Engine will not start or
remain running while
trying to start.
Generator suddenly
stops running.
30 | Westinghouse Outdoor Power Equipment
WARNING
POTENTIAL CAUSE
1. Circuit breakers are tripped.
2. The power cord's plug connector is not
fully engaged in the generator's outlet.
3. Faulty or defective power cord
4. Faulty or defective electrical appliance
5. GFCI outlet is tripped
6. If trying 1-5 above does not solve
the problem, the cause might be the
generator has a fault.
1. Fuel shutoff valve is in the OFF
position.
2. Generator is out of gasoline.
3. Fuel flow is obstructed.
4. Starting battery may have insufficient
charge
5. Dirty air filter
6. Low oil level shut down switch is
preventing the unit from starting.
7. Spark plug boot is not fully engaged
with the spark plug tip.
8. Spark plug is faulty.
9. Stale fuel
10. If trying 1-9 above does not solve
the problem, the cause might be the
generator has a fault.
1. Generator is out of fuel.
2. The low oil shut down switch has
stopped the engine.
3. Too much load
4. If trying 1-3 above does not solve the
problem,the cause might be a fault in the
generator.
SOLUTION
1. Reset the circuit breakers and check for
overload condition.
2. Verify plug connector is firmly engaged
in the generator's outlet. If using the 240V
outlet, make sure plug connector is rotated
1/4 turn in the clockwise direction.
3. Replace power cord.
4. Try connecting a known good appliance
to verify the generator is producing electrical
power.
5. Switch the GFCI breaker to operating
position.
6. Take the generator to your nearest
authorized service dealer.
1. Move the fuel shut off valve to the ON
position.
2. Add gasoline to the generator.
3. Inspect and clean fuel delivery passages.
4. On electric start models only. Check
battery output and charge battery as
necessary.
5. Check and clean the air filter.
6. Check oil level and add oil if necessary.
7. Firmly push down on the spark plug boot
to ensure the boot is fully engaged
8. Remove and check the spark plug.
Replace if faulty.
9. Drain fuel and replace with fresh fuel.
10. Take the generator to your nearest
authorized service dealer.
1. Check fuel level. Add fuel if necessary.
2. Check oil level and add oil if necessary .
3. Restart the generator and reduce the
load.
4. Take the generator to your nearest
authorized service dealer.
Publicité
Table des Matières
