Emerson CF279BS00 Mode D'emploi page 8

3. Ceiling Fan Assembly
3.9
Retighten the two Phillips Head Set Screws evenly to
secure the Downrod to the Motor Coupler in a vertical
position (Figure 9).
WARNING
!
It is critical that the set screws in the motor coupler are
securely tightened. Failure to verify that the set screws
are properly installed could result in the fan falling.
3.10
Make sure the Grommet is properly installed in the Motor
Coupler Cover, then slide the Motor Coupler Cover on the
Downrod until it rests on the Motor Housing (Figure 10).
3.11
Place the Ceiling Cover over the Downrod (Figure 11).
Be sure that the Ceiling Cover and the Motor Coupler
Cover are both oriented correctly (Figure 11).
(Continued)
RETIGHTEN
PHILLIPS HEAD
SET SCREW (2)
Figure 9
MOTOR
HOUSING
Figure 10
Figure 11
8
DOWNROD
MOTOR
COUPLER
DOWNROD
GROMMET
COUPLER
COVER
DOWNROD
CEILING
COVER
ETL Model No.: CF279