Human Touch Perfect Chair PC-420 Mode D'emploi Et D'entretien page 9

S P
C
Install the control panel and arm caps
NOTE: The Comfort Upholstery Package does not have a control panel; follow steps 1, 3, 4, 8, and 9
to install the arm caps and lower body pad.
1. Remove the six screws taped to the underside of the left-hand armrest cap.
2. Place the control panel into position on the armrest, above the chair arm as shown (Fig.14).
Fig.14
3. Place the arm cap into position and press down firmly (Fig.15).
Fig.15
humantouch.com
Control panel
Arm cap
12 12
4. While pressing down on the armrest cap, secure it using a Phillips-head screwdriver and three
screws (Fig.16).
Front
5. Using a Phillips-head screwdriver, remove the screw and washer that secure the left-hand glide rail safety
tip (Fig.17).
6. Place the control panel cable loop into position over the screw hole, then replace the screw and washer
to secure it. (Fig.17).
7. Place the cap into position on the right-hand armrest core, then secure it using three screws.
Screw
Washer
Cable loop
Rear
Fig.16
Glide rail safety tip
Fig.17
13