Maintenance - Dexter 260MT3-QC.5 Mentions Légales & Consignes De Sécurité

FR
6. Operation
ES
4) Cutting
PT
tools are subject to high wear if used for extended periods.
IT
5) Sanding
EL
The material removal rate and sanding result are primarily determined by the
choice of sanding sheet, the preselected orbital stroke rate level and the contact
PL
pressure. Only immaculate sanding sheets achieve good sanding performance and
make the power tool last longer.
UA
To sand corners, edges and hard-to-reach areas accurately, you can also work with
the tips alone or with an edge of the sanding plate.
RO
The sanding sheet may heat up signi cantly when used to sand speci c points
rather than entire surfaces. Reduce the orbital stroke rate and contact pressure and
EN
allow the sanding sheet to cool down at regular intervals.
6) Scraping
Select a high orbital stroke rate level for scraping. Work on a soft surface (e.g.wood)
at a at angle and with low contact pressure. Failure to do so may cause the scraper
to cut into the surface underneath.
application tool overheating and jamming

7. Maintenance

a) To prevent accidents, always unplug the saw from the power source before
cleaning or performing any maintenance the saw may be cleaned most e ectively
using compressed air. Always wear safety goggles when using compressed air. If
compressed air is not available, use a brush to remove dust and chips from the saw.
b) Motor ventilation vents and switch levers must be kept clean and free of
foreign matter. Do not attempt to clean by inserting pointed objects through
openings.
c) Never use any caustic agents to clean plastic parts. Such as: gasoline, carbon
tetrachloride, chlorinated cleaning solvents, ammonia and household cleaners
140
NOTE : When cutting wall tiles, please bear in mind that the application
NOTE : While working, move the power tool back and forth to prevent the