Pentax HP Serie Instructions D'utilisation page 60

1.
Connect "Securoil" to the hole in the bearing housing
using a connection pipe.
2.
Check the correct alignment of the connection pipe axis
(fig. 1).
2.
1.
If wrongly assembled, as in the - fig. 2- the oil flow
could be interrupted.
Possible causes of flow interruption are:
? hole badly realised
? connection pipe misalignment
? square support misalignment.
In this case, check again the alignment of the
assembly various parts and, if needed , make a new
hole in the bearing housing . keep the oil flow
passages clean to allow easy flowing.
ASSEMBLY INSTRUCTIONS
Fig. 1
Fig. 2
25