Read the user's manual carefully.
Follow the instructions in the
GB
manual. Use the manual to make
yourself familiar with the operating
1. Assembly
1.1. Checking all parts are included
The Hand Lawnmower box contains
the following parts:
Hand Lawnmower
.
1 upper section of the
.
guide handle
1 middle section of the
.
guide handle
2. Setting the cutting height
Place the mower on a firm level-
surface. Loosen the two wing nuts.
Place the countersunk screws in the
required position. Now tighten the
wing nuts. After setting, the roller
must again lie parallel to the bot-
tom blade.
Model
Longest
cut
Classic 30
43 mm
Classic 35
43 mm
3. How to cut properly
The hand mowers can cut grass
up to the following lengths:
Model
Length in mm
Classic 30
100
Classic 35
100
If you want a well-looked after
lawn, the grass must always be
kept shorter.
At the beginning of the cutting
period, and with new lawns, select
a relatively high cutting height and
gradually reduce this each time
you mow the lawn. If you want to
have a well-manicured lawn, set
the cutting height to approx. 2 cm.
10
parts and with the correct use of
your lawnmower.
For safety reasons, children and
young persons under 16, and
1 lower section of the
.
guide handle
Assembly parts for the guide
.
handle in a plastic bag
User's manual
.
(Fig. B)
A
Attention!
Never use the mower near people,
especially children, or animals.
The user is responsible for all
injuries.
Before using the mower, always
Shortest
check the nuts, bolts and working
cut
tools for wear or damage. Replace
worn or damaged blades in sets.
17 mm
17 mm
Always make sure you have a
clear view when using the mower.
Cut the grass every week if possi-
ble. Frequent cutting forces
the growth into the cut stalk and
makes it resistant.
If possible, always cut the grass
when it is relatively dry. To obtain
a clear pattern, push the mower
in straight lines at an even walking
pace. The cutting paths should
overlap by a few centimetres to
avoid leaving strips of grass.
A
Attention!
Be careful! The rotating blade
roller can cause injuries!
persons unfamiliar with the
user's manual, must not use this
lawnmower.
1.2. Assembling the guide handle
(Fig.A)
Screw the push bar together with
the enclosed screws. Now slide the
bar on the left-hand side with the
drill hole over the bar bolt.
On the right-hand side, press the
push bar in slightly to slide the hole
over the second bolt.
When mowing, wear proper shoes
with non-slip gripping soles and
long trousers.
Before using the mower, check the
area you want to cut and remove
any stones, pieces of wood, wire
and similar objects. The blades can
catapult objects like this at great
speed.
If the blades or the mower hit any
solid object or obstruction, have
the mower examined by an expert.
Always keep the safety distance
between the user and blade roller
shown by the push bar.
Take extra care when mowing on
embankments and slopes: make
sure you are on firm ground and
always wear shoes with non-slip
gripping soles and long trousers.
Always mow across a slope.
Take special care when moving
backwards and when pulling
the mower. Danger of stumbling !
Never place your hands or feet
on or underneath moving parts.