Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing and installing the battery
pack
Charging the battery pack
ASSEMBLY
Saw blade assembly and removing
WARNING: Always remove the
battery before changing the blade!
Hex key storage
OPERATION
Safety on/off switch
WARNING: To avoid cutting
injury from the sharp blade,
please don't put your hands around
the base plate.
Cutting depth adjusting
Cutting guide
Bevel cut
12
NOTE: Bevel cutting can't be used
under EXACTRACK
Sawdust removal
EXACTRACK
What is EXACTRACK
EXACTRACK
is an innovative function, which can
TM
help to make a straight cut easier by keeping the
blade flush against the cutting guide board.
Safety notes
WARNING:
Blade is sharp. Always wear protective
gloves.
Keep your hands off from the lower blade
guard after opening the lower blade guard.
EXACTRACK
operation scope
TM
1. EXACTRACK
operates between 0~1-5/8'' in
TM
depth. (See Fig. I)
2. EXACTRACK
TM
does not work with any angle of bevel cut.
Before operation
WARNING: Make sure battery is not
installed prior to making any adjustments
to the saw, and please place the battery pack
nearby the saw.
Cordless Circular Saw
See Fig. A1
See Fig. A2
See Fig. B
See Fig. C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
mode.
TM
See Fig. H
TM
?
TM
works only with 90 degree cut, it
1. Adjust the desired cutting depth (range 0~1-5/8'').
(See Fig. I)
2. Turn the lever to EXACTRACK
3. Mark the desired cut line on the workpiece, then
FIGURE
clamp the cutting guide board (not supplied) to make
the board edge right on the cut line, the length of the
cutting guide board should leave 9" or 230mm longer
at the both ends. (See Fig. K1)
4. Place the EXACTRACK
on the top of cutting guide board (not supplied),
and ensure the main-base plate is sitting on the
workpiece. (See Fig. K2)
5. Open the lower blade guard manually (
your hands off the blade), push the saw against the
side of the cutting guide board, then release the hand
off the lower blade guard. (See Fig. K3)
Operation
1. Install the battery.
2. Please hold the saw firmly with both hands and
make sure the main base plate fits securely against
the cutting guide board (not supplied) during cutting.
(See Fig. K4)
3. Switch on the tool to start cutting (See Fig. K5)
STANDARD mode
For regular 90 degree or bevel cutting (disable
EXACTRACK
mode and then your tool can be used as a standard
circular saw. (See Fig. L)
The STANDARD mode can be used in the cutting
depth of 0~2-1/8'' (90 degree), 0~1-1/2'' (45 degree).
For product information, go to www.worx.com
and see How To video.
mode. (See Fig. J)
TM
sub-base plate (red part)
TM
fucntion), turn the lever to STANDARD
TM
keep
EN
Publicité
