Castelgarden XZ 180 PW Manuel D'utilisation page 55

(Translation of the Original Instructions)
9.9.4 Cleaning
If the battery terminals are coated with oxide, they
should be cleaned.
Clean the battery terminals with a wire brush and
lubricate them with terminal grease.
9.10 AIR FILTER, ENGINE
For the frequency of this intervention
see chapter 13.
For this maintenance operation, see
also the manual for the engine supplied
with the machine.
9.10.1 Cleaning / Replacement (30)
For the frequency of this intervention
see chapter 13.
NOTE! The filters should be cleaned/re-
placed more often if the machine opera-
tes on very dusty ground.
Remove/install the air filters as follows:
1. Clean the area around the filter cover (30:A).
2. Open the cover (30:A) by unscrewing the
opening k nob (30:B).
3. Remove the filter element (30:C + 30:D).
4. Remove the sponge pre-filter (30:D) from the
cartridge (30:C).
5. Tap the cartridge (30:C) on a solid surface
and blow with compressed air from the inside
to remove dust and debris.
6. Wash the sponge pre-filter (30:D) with water
and detergent and leave it to dry in the air.
7. Clean any dust and debris from the inside of
the filter housing (30:E) taking care to close
the intake duct with a rag (30:F) to prevent
foreign bodies entering the engine.
8. Remove the rag (30:F), refit the filter element
(30:D + 30:C) in its housing and refit the co-
ver (30:A).
9.10.2 Replace the spark plug
For the frequency of this intervention
see chapter 13.
Before removing the spark plug, clean around its
mounting.
For the type of spark plug and relative spark gap,
please refer to "0 TECHNICAL DATA TABLE".
ENGLISH
9.11 LUBRICATION (31)
For the frequency of this intervention
see chapter 13.
Object Action
Centre
point
Steering
chains
Tensioning
arms
Control
cables
9.12 FUSES (32)
Destination
Fuel valve power supply
Electrical cutting height
adjustment power supply
Electrical system power supply 30 A
10 ASSISTANCE AND REPAIRS
This manual provides all the necessary infor-
mation to run the machine and for correct basic
maintenance operations which can be performed
by the user.
Any regulations and maintenance operations not
described herein must be carried out by your De-
aler or Authorized Service Centre, which have the
necessary knowledge and equipment to ensure
that the work is carried out correctly, maintaining
the correct degree of safety and the original opera-
ting conditions of the machine.
4 grease nipples
Use a grease nipple filled
with multi-purpose grease.
Pump until the grease
seeps out.
Brush the chain clean
with a wire brush.
Lubricate with universal
chain spray.
Lubricate the support
points with oil
when each control is
activated.
Ideally this operation
should
be carried out by two
people.
Lubricate the cable ends
with oil
when each control is
activated.
This operation must be
carried out by two people.
Fuse
10 A
20 A
EN
Fig.
31A
-
31B
31C
21