Table des Matières
Publicité
EN
Problem
1. The starter motor does not
turn.
2. The starter motor turns but
the engine doesn't start.
With the ignition key in the
start position, the starter
motor turns but the engine
doesn't start.
3. Difficulty in engine start-up
or engine runs irregularly.
4. Drop in engine performance
during cutting.
5. The engine stops for no
apparent reason.
6. Uneven cutting.
7. Abnormal vibration during
use.
8. With the engine running,
activation of the traction pedal
does not move the machine.
If any of the faults listed below occurs, replace the relevant fuse.
9. The engine does not start or
starts and stops immediately.
The battery is charged.
10. Electrical cutting height
adjustment does not work.
11. All electrical functions are
out of operation. The battery
is charged.
If problems persist after the operations above have been performed, contact your dealer.
Warning! Never attempt to carry out complicated repairs without the necessary tools or
technical ability. Any poorly performed interventions will automatically nullify the warranty
and exonerate the manufacturer from all liability.
24
ENGLISH
14 TROUBLESHOOTING
Probable cause
Battery not charged enough.
Battery not connected.
Fuse 20A blown.
Fuel cock closed.
No fuel flow.
Ignition fault.
Carburettor problems.
Forward speed too high in rela-
tion to the cutting height.
- Fuel tank empty.
- Try to restart the engine.
The cutting means sharpness
level is low.
Forward speed too high in
relation to the height of the grass
being cut.
The cutting means assembly is
full of grass.
- Unbalanced cutting means.
- Slackened cutting means.
- loose components.
- possible damage.
"Disengage transmission" lever in
the disengaged position.
Fuse 10A blown.
Fuse 20A blown.
Fuse 30A blown.
(Translation of the Original Instructions)
Remedy
Recharge the flat battery.
Check the connections.
Replace the fuse
Open the fuel cock.
- Check the fuel level in the tank.
- Check the fuel filter.
- Check the spark plug cap is
securely in place.
- Check the spark gap and that
the electrodes are clean.
Clean or replace the air filter.
Reduce the forward speed and/
or raise the cutting height.
Fill the fuel tank (if the problem
persists, contact an authorised
assistance centre).
Check the tyre pressure.
Contact an authorised assistan-
ce centre.
Reduce the forward speed and/
or raise the cutting height.
- Wait for the grass to dry.
- Clean the cutting means assembly.
Contact an authorised assistan-
ce centre for inspection, replace-
ment or repair operations.
Engage the transmission.
Replace fuse 10A.
Replace fuse 20A.
Replace fuse 30A.
Publicité
Table des Matières
