Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac ESL Serie Manuel D'utilisation

L'aspirateur assistant pour l'atelier pour déchets secs/humides
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FIGURE 9
FIGURE 10
FIGURE 11
FIGURE 12
16. Repeat steps 11 through 15 for other wheel
assembly.
17. Return tank to upright position.
ACCESSORY BASKET
ASSEMBLY
(Not standard with all models)
FIGURE 13
PAGE 6
12. Insert wheel plug (with
tab in upward position)
through wheel and axle
housing aligning the tab on
the plug with the slot in the
axle housing. FIGURE 9.
13. Place assembled wheel
on hard flat surface. Apply
pressure to snap assembly
together. FIGURE 10.
14. Insert screw provided
through back of axle housing.
FIGURE 11.
15. Slide axle housing into
dovetail slot at rear of tank:
axle housing is tapered and
should slide into dovetail
slot without excessive force.
FIGURE 12. Tighten screw.
18. With rear of tank facing
you, take accessory basket and
position with tabs facing rear of
tank. FIGURE 13.
FIGURE 14
20. Press down until basket is secured into place.
TOOL HOLDER
ASSEMBLY
(Not standard with all models)
21. Replace tank cover and apply pressure with thumbs
to each latch until it snaps tightly in place. Make sure
both lid latches are clamped securely.
FIGURE 15
FIGURE 16
24. Press down until tabs snap into place.
NOTE: TOOL HOLDER NOT COMPATIBLE WITH
ACCESSORY BASKET.
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
19. Insert tabs of accessory
basket into slots on rear of
tank. FIGURE 14.
22. With rear of unit facing
you, take tool holder and
position it with the tabs
facing rear tank cover.
FIGURE 15.
23. Press tabs of tool holder
into the slots on mounting
lugs on rear of tank cover.
FIGURE 16.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Eslsq5505914411

Table des Matières